Search
Now showing items 11-17 of 17
Hot deformation behavior of ultra-fine grained pure Ti
(Trans Tech Publications, 2013-11)
In the present study, compression tests were performed at a strain rate of 0.001 to 0.1 s(-1) and in the range of 600 degrees C to 900 degrees C to investigate the high temperature deformation behavior and flow stress model ...
Direct liquid cooling of high flux LED systems: hot spot abatement
(ASME, 2013)
With the recent advances in wide band gap device technology, solid-state lighting (SSL) has become favorable for many lighting applications due to energy savings, long life, green nature for environment, and exceptional ...
Special issue based on the Eurotherm Seminar 95-computational thermal radiation in participating media IV
(Elsevier, 2013-10)
Characterization of chemically modified thin films for optimization of metal CMP applications?
(Cambridge University Press, 2013)
Metal CMP applications necessitate the formation of a protective oxide film in the presence of surface active agents, oxidizers, pH regulators and other chemicals to achieve global planarization. Formation and mechanical ...
Heart motion prediction based on adaptive estimation algorithms for robotic assisted beating heart surgery
(IEEE, 2013)
Robotic-assisted beating heart surgery aims to allow surgeons to operate on a beating heart without stabilizers as if the heart is stationary. The robot actively cancels heart motion by closely following a point of interest ...
Design of a parallel robot for needle-based interventions on small animals
(IEEE, 2013-02)
In this paper, a novel 5-degrees-of-freedom robot for performing needle-based interventions on small animal subjects is presented. The robot can realize dexterous alignment of the needle using two parallel mechanisms, and ...
A torque matched aerodynamic performance analysis method for the horizontal axis wind turbines
(Wiley, 2013-11)
An analysis method is developed to test the operational performance of a horizontal axis wind turbines. The rotor is constrained to the torque–speed characteristic of the coupled generator. Therefore, the operational ...
Share this page