Search
Now showing items 141-150 of 253
Self-cleaning ability quantization of textiles with degussa P-25
(Trans Tech Publications Inc., 2018)
This study proposes a systematic quantification of effectiveness of the Degussa P-25 titania particles used as a benchmark in photocatalytic applications to standardize ability of self-cleaning textile applications and to ...
The effect of nanoparticle type and nanoparticle mass fraction on heat transfer enhancement in pool boiling
(Elsevier, 2017-06)
Determining the heat transfer performance with nanofluids is of cardinal importance in the utilization of nanofluids in thermal systems. This study presents an experimental investigation on nucleate pool boiling heat ...
Experimental study on heat transfer of multi-walled carbon nanotubes/water nanofluids in horizontal microtubes
(ASME, 2016)
In this study, heat transfer characteristics of multi-walled carbon nanotube based nanofluids were investigated in horizontal microtubes with outer and inner diameters of ∼1067 and ∼889 μm, respectively. Carbon nanotubes ...
A design tool for direct and non-stochastic calculations of near-field radiative transfer in complex structures: The NF-RT-FDTD algorithm
(Elsevier, 2017)
Advances in nanotechnology and nanophotonics are inextricably linked with the need for reliable computational algorithms to be adapted as design tools for the development of new concepts in energy harvesting, radiative ...
An integrated homogenization–based topology optimization via RBF mapping strategies for additively manufactured FGLS and its application to bandgap structures
(Springer Nature, 2020)
The manufacturing of lattice structures has been greatly facilitated thanks to the advances in additive manufacturing. Functionally graded lattice (FGL) structures, a major class of such structures, developed using topology ...
The effect of curvic coupling joints on the roto rdynamic characteristics of gas turbines with tie-shaft
(Canadian Acoustical Association, 2019)
The importance and use of curvic coupling joints are garnering interest in many aero-engine rotordynamics applications thanks to their benefits such as lower stress, higher service life, reliable positioning, precise ...
Effect of chemical mechanical polishing on surface nature of titanium implants FT-IR and wettability data of titanium implants surface after chemical mechanical polishing implementation
(Elsevier, 2017)
Bioactivity of titanium depends on the quality and characteristics of its surface oxide film. Through implementation of chemical mechanical polishing (CMP) process on titanium plates, a protective oxide (titania) film grows ...
A personal navigation system using mems-based high-density ground reaction sensor array and inertial measurement unit
(IEEE, 2015)
This paper describes a prototype personal navigation system developed for position tracking under GPS denied environments by employing a commercial inertial measurement unit (IMU) and a MEMS-based ground reaction sensor ...
Investigation of power distribution on an axial fan
(IEEE, 2016)
Forced convection cooling systems utilize fans which can be axial or radial, small or large in many different configurations. Efficiency of a fan depends on its electrical and mechanical designs as well as the environmental ...
Flow and heat transfer study of an impinging piezoelectric fan over a vertical surface
(ASME, 2016)
Piezoelectric fans are low-form-factor cooling devices, which have gained recent attention for electronics cooling. These devices feature a vibrating blade, which sheds vortices from its tip during its motion. The performance ...
Share this page