Search
Now showing items 821-830 of 1525
SDNHAS: An SDN-Enabled architecture to optimize qoe in http adaptive streaming
(IEEE, 2017-10)
HTTP adaptive streaming (HAS) is receiving much attention from both industry and academia as it has become the de facto approach to stream media content over the Internet. Recently, we proposed a streaming architecture ...
Design for ARINC 653 conformance: architecting independent validation of a safety-critical RTOS
(IEEE, 2014)
The ARINC 653 specification not only provides a standard application programming interface for an RTOS, but also specifies how to validate an ARINC 653 based RTOS. ARINC 653 Part 3 Conformity Test Specification specifies ...
Decomposing transverse momentum balance contributions for quenched jets in PbPb collisions at √=2.76sNN=2.76 TeV
(Springer International Publishing, 2016)
Interactions between jets and the quark-gluon plasma produced in heavy ion collisions are studied via the angular distributions of summed charged-particle transverse momenta (pT) with respect to both the leading and ...
Effect of chemical mechanical polishing on surface nature of titanium implants FT-IR and wettability data of titanium implants surface after chemical mechanical polishing implementation
(Elsevier, 2017)
Bioactivity of titanium depends on the quality and characteristics of its surface oxide film. Through implementation of chemical mechanical polishing (CMP) process on titanium plates, a protective oxide (titania) film grows ...
Event activity dependence of (nS) production in=5.02 TeV pPb and=2.76 TeV pp collisions
(Springer Science+Business Media, 2014-04)
The production of (1S), (2S), and (3S) is investigated in pPb and pp collisions at centre-of-mass energies per nucleon pair of 5.02 TeV and 2.76 TeV, respectively. The datasets correspond to integrated luminosities of about ...
Measurement of jet multiplicity distributions in t(t)over-bar production in pp collisions at root s=7TeV
(Springer Science+Business Media, 2014-08)
The normalised differential top quark-antiquark production cross section is measured as a function of the jet multiplicity in proton-proton collisions at a centre-of-mass energy of 7 TeV at the LHC with the CMS detector. ...
A personal navigation system using mems-based high-density ground reaction sensor array and inertial measurement unit
(IEEE, 2015)
This paper describes a prototype personal navigation system developed for position tracking under GPS denied environments by employing a commercial inertial measurement unit (IMU) and a MEMS-based ground reaction sensor ...
Measurement of the t-channel single-top-quark production cross section and of the |V (tb)| CKM matrix element in pp collisions at root s=8 TeV
(Springer Science+Business Media, 2014-06)
Measurements are presented of the t-channel single-top-quark production cross section in proton-proton collisions at root s = 8 TeV. The results are based on a data sample corresponding to an integrated luminosity of 19.7 ...
Search for neutral resonances decaying into a Z boson and a pair of b jets or τ leptons
(Elsevier, 2016-08-10)
A search is performed for a new resonance decaying into a lighter resonance and a Z boson. Two channels are studied, targeting the decay of the lighter resonance into either a pair of oppositely charged τ leptons or a ...
Measurement of the top-quark mass in t(t)over-bar events with lepton plus jets final states in pp collisions at root s=7 TeV
(Springer Science+Business Media, 2012-12)
The mass of the top quark is measured using a sample of t (t) over bar candidate events with one electron or muon and at least four jets in the final state, collected by CMS in pp collisions at root s = 7TeV at the LHC. A ...
Share this page