Sajadifar, S. V.Ghobadlou, Ali HosseınzadehRichter, J.Krochmal, M.Wegener, T.Bolender, A.Heidarzadeh, A.Niendorf, T.Yapıcı, Güney Güven2023-06-142023-06-142022-101438-1656http://hdl.handle.net/10679/8395https://doi.org/10.1002/adem.202200384The novel combination of friction stir processing (FSP) and additive manufacturing (AM) is studied herein. Laser-based powder bed fusion of metals (PBF-LB/M) is used to establish 316 L stainless steel with a bimodal microstructure. Upon FSP, the as-built bimodal microstructure with an average grain size of 179 μm is transformed into the unimodal microstructure containing ultrafine grains with an average grain size of 1.2 μm. Results obtained by mechanical testing reveal that after FSP; the hardness, the yield point, and the ultimate strength of additively manufactured 316 L are enhanced by 45%, 77%, and 62%, respectively. Microstructure assessment reveals that such a unique improvement in the mechanical properties is due to considerable structural refinement leading to grain boundary strengthening. Energy-dispersive X-Ray diffraction analysis reveals that phase transformation does not occur upon FSP. Fracture analysis further indicates that severe plastic deformation (SPD) during FSP can promote the transformation of coarse voids to fine voids and, hence, densification of as-built parts.enginfo:eu-repo/semantics/restrictedAccessArticle241000079258040000110.1002/adem.202200384FracturesFriction stir processingLaser powder bed fusionMechanical propertiesMicrostructuresStrengths2-s2.0-85129618856